Note: product analysis and/or label may differ depending on State or Country regulations.


A broad spectrum botanical fungicide for use in agriculture, fruits, nuts, vegetables, ornamentals, landscapes, turf, greenhouses, and nurseries.

Only protected handlers may be in the application area. Do not apply this product in a way that will contact workers or other persons either directly or through drift.


The use directions of this product are based on the results of product testing programs on a wide variety of plants. However, it is impossible to test this product on all species and cultivars. The phytotoxicity of KeyPlex Sporan EC2 has been assessed on a wide variety of common ornamental plants with no phytotoxicity. However, not all plant species and their varieties and cultivars have been tested with KeyPlex Sporan EC2 applied alone or with a possible tank mix combinations, sequential pesticide treatments, and adjuvants and surfactants. Local conditions also can influence plant tolerance and may not match those under which testing has been conducted. Therefore, before using KeyPlex Spora EC2, test the products on a sample of the plant and/or seedling. Do not apply on plant when the temperature is 90° F or above.

KeyPlex Sporan EC2 can be applied through most standard or field type sprayers after dilution and mixing with water in accordance with label instructions.
For best results, spray coverage should be uniform and complete. Always read and follow label directions for adjuvants.

PREHARVEST INTERVAL: KeyPlex Sporan EC2 may be applied to crops at any time up to and including the day of harvest. Use lower rates for light to moderate infestations and higher rates for heavy infestations. Repeat application as required to maintain the desired level of control.

Mixing and Application Instructions
Apply spray solutions in properly maintained and calibrated equipment capable of delivering the desired volumes. Always clean tank, pump and lines thoroughly with water after use.

Add KeyPlex Sporan EC2 to one-half (1/2) tank under agitation containing water of 45° F or greater before filling to desired level. When combining with other products, such as adjuvants, insecticides, fungicides, fertilizers or nutrients, add these products first when the tank is approximately 1/2 full. Ensure that there is good agitation while mixing for complete emulsification. Maintain agitation during spray application. In areas with hard water (water with a total hardness of greater than 200 ppm), it is recommended to completely fill tank with water first and then add a water softener, mix thoroughly, add the appropriate quantity of KeyPlex Sporan EC2, and mix thoroughly. It is critical that the water softener be added to the entire quantity of water and mixed thoroughly before introducing the KeyPlex Sporan EC2 to achieve maximum emulsion.

Application Equipment and Techniques
Spray droplet size should be adjusted to maximize coverage, minimize drift, and allow application to the intended exposure area only.

Boom Equipment
For best insect control using hydraulic or hydraulic air assist equipment, use the recommended rate of this product in sufficient gallons of spray solution per acre as a broadcast spray. Spray should thoroughly wet foliage but not run off.

Hand-held and High Volume Equipment
Spray-to-wet applications of this product may be made with knapsack and backpack sprayers, pump-up pressure sprayers, handguns, hand wands, and other hand-held spray equipment and vehicle mounted high volume spray equipment. For the most efficient use of spray mixture, spray all leaf surfaces uniformly and completely to wetness.


• Prior to application, check the aircraft/helicopter spray equipment for uniformity of spray pattern, spray width and output.
• Apply a minimum of 15 gallons per acre of diluted product.
• Optimum results are obtained when plant foliage is not too dense.
• Use an output that will ensure optimum product penetration and coverage.
• Make aerial applications when the wind velocity favors on-target product deposition (approximately 3 to 10 mph).
• Do not apply when wind velocity exceeds 15 mph.
• Low humidity and high temperature increase the evaporation rate of spray droplets and therefore the likelihood of good coverage.
• Use the largest droplet size consistent with good pest control.
• Formulation of very small droplets may be minimized by appropriate nozzle selection, by orientating nozzles away from the air stream as much as possible, and by avoiding excessive spray boom pressure.
• Spray should be released at the lowest height consistent with pest control and flight safety. Applications more than 10 feet above the crop canopy is not recommended.

APPLICATION RATES: SPORAN® EC2 is an effective fungicide for prevention and control of various fungal diseases. Applications should be made once the disease is observed.

Crops: Including but not limited to… Diseases: Including but not limited to… Application Rate in 100 gallons per Acre for Ground Applications
Legume and Fruiting Vegetables: Beans, Eggplants, Lentils, Peas, Peanuts, Peppers and Tomatoes Bacterial Spot, Early Blight, Early Leaf Spot, Gray Mold, Late Blight, Powdery Mildew, Bean Rust, Botrytis Neck, Pin Rot, Rust 1.0 - 3.0 pt
Bulb, Cole and Leafy Vegetables: Broccoli, Cabbage, Cauliflower, Celery, Garlic, Lettuce, Onion and Spinach Alternaria Leaf Spot, Downy Mildew, Gray Mold, Powdery Mildew, Black Root Rot, Botrytis Neck Rot, Pin Rot, Rust 1.0 - 3.0 pt
Cucurbits: Cantaloupes, Cucumbers, Melons, Squashes and Watermelons Alternaria Leaf Spot, Downy Mildew, Powdery Mildew 1.0 - 3.0 pt
Root and Tuber Vegetables: Potatoes, Radishes, Sweet Potatoes and Turnips Bacterial Spot, Early Blight, Early Late Blight, Powdery Mildew, Black Root Rot 1.0 - 2.0 pt
Small Fruits and Berries: Blackberries, Blueberries, Cranberries, Raspberries and Strawberries Anthracnose Fruit Rot, Downy Mildew, Gray Mold, Powdery Mildew, Sour Rot 1.0 - 3.0 pt Note: Raspberries do not exceed 3 pts per acre
Grapes and Hops: Grapes (Raisin, Table and Wine) Powdery Mildew, Downy Mildew, Black Rot, Botrytis Bunch Rot 1.5 - 3.0 pt
Herbs: Anise, Basil, Dill, Mint, Peppermint, Spearmint, Thyme, and Wintergreen Powdery Mildew 1.0 - 2.0 pt
Stone Fruits and Pome Fruits: Apples, Apricots, Cherries, Peaches, Nectarines, Olives, Pears, Plums, Prunes, Pomegranates and Persimmons Scab, Powdery Mildew, Brown Rot Blossom Blight, Anthracnose, Rust, Gray Mold, Cherry Leaf Spot, Fruit Brown Rot, Black Rot 2.0 - 3.0 pt
Citrus and Sub Tropicals: Avocados, Lemons, Grapefruit, Oranges, Papayas, Bananas, Plantains, Mangos Alternaria Rot, Botrytis Rot, Greasy Spot, Scab, Brown Rot 2.0 - 3.0 pt
Nuts: Almonds, Cashews, Pecans, Pistachios and Walnuts Scab, Walnut Blight, Brown Rot Blossom Blight, Anthracnose, Rust 2.0 - 4.0 pt
FieldCrops: Corn, Cotton, Sorghum, Soybeans, Sweet Corn and Tobacco Bacterial Blight, Leaf Spots, Anthracnose, Rust, Powdery Mildew, Downey Mildew, Seedling Blight 1.0 - 3.0 pt
Backyard Fruit and Nut Trees Powdery Mildew 16 - 48 fl oz Thoroughly wet vegetation

For aerial applications use a minimum of 15 gallons of spray volume per acre. Complete coverage of foliage is essential to achieve control. The foliage should be completely WET, but avoid runoff. The use of a spreader and/or penetrant adjuvant improves product performance.

Fusarium Blight (F. roseum), Red Thread 7-10 fl oz

10-14 fl oz
Begin when grass greens up in spring / 7 to 14 days.

Use during favorable disease conditions / 7 days.
Dollar Spot (Sclerotinia) 10-14 fl oz

14 fl oz
Beginwhen grass greens up in spring / 7 to 14 days.

Use during favorable disease conditions / 7 days.
Leaf Spot (Helminthosporiumspp.) 5-7 fl oz Begin when disease appears.
Rhizoctonia Brown Patch 10-14 fl oz Use during favorable disease conditions / 3 to 5 days.
Pythium Blight 14 fl oz Begin at first sign of disease / 5 days or more often during favorable disease conditions
Leaf Rust, Stem Rust, Stripe Rust 5-7 fl oz Begin when disease first appears / 7 to 10 days

GREENHOUSE, NURSERY AND LANDSCAPE DISEASE CONTROL SPORAN® EC2 is an effective fungicide for the prevention and control of various fungal diseases including anthracnose, rust, scab and black spot on roses.

Anthracnose (Colletotrichium spp.)

Black Spot (Diplocarpon rosae)

Botrytis (Botrytis spp.)

Downy Mildew (Peronospora spp.)

Leaf spot (Septoria spp.)

Powdery Mildew (Erysiphy spp., Microsphaera spp., Oidium spp., Podosphaera spp., Sphaeratheca spp.)

Rust (Gymnosporangium spp., Phragmidium spp.)

Scab (Cladosporium spp.)

Scab (Venturia inaequalis)

Myrothecium (Myrothecium spp.)
32-48 fl oz/100 gallon in greenhouses (potted plants, flowering bench crops) and outdoor flowering plants. 64-84 fl oz/100 gallon in outdoor woody plants. Apply to the point of drip before disease is detected or when conditions are favorable for disease development. Continue at 7-14 day intervals until the threat of disease is over. Under heavy pressure, use the highest rate and the shortest interval. Under light disease pressure, the application may be extended.

LIVERWORT AND MOSS CONTROL SPORAN® EC2 may be applied in nurseries, forestry nurseries, greenhouses, and landscape settings (sidewalks, patios, decks, etc.) to control byrophytes (liverworts, mosses, and hornworts). Apply SPORAN® EC2 at 0.8% to 1.6% (1 to 2 fluid ounces per gallon of water, respectively). In nurseries and greenhouses where bryophytes may occur in potted plants, make a directed spray on the bryophytes wetting heavily. Avoid spraying foliage of potted plant. Some nursery plants, such as conifer seedlings, may tolerate a broadcast application but a test area should be evaluated before making large scale applications.

TURF AND LAWNS DISEASE CONTROL SPORAN® EC2 is an effective fungicide for the prevention and control of various fungal diseases including dollar spot and brown patch.

Don't Know What You Need? We Can Help

Select A Crop To Get Started